× Welcome to the CMASS forum!

A place to discuss anything related to CMASS (and other) launches.

Quest Q-Jet motors (C,D)

  • tlainhart
  • tlainhart's Avatar Topic Author
  • Offline
  • Junior Boarder
  • Junior Boarder
More
3 weeks 6 days ago #9960 by tlainhart
Quest Q-Jet motors (C,D) was created by tlainhart
Anyone have experience with the C or D 18mm Q-Jet motors to share, esp. on the latter? Where did you end up buying them from?

-- Todd

Please Log in or Create an account to join the conversation.

More
3 weeks 6 days ago #9961 by DeltaVee
Replied by DeltaVee on topic Quest Q-Jet motors (C,D)
Spare time shop had a full rack of them last time I was there a few weeks back... I've never used them... don't like how they "hissssss"

Please Log in or Create an account to join the conversation.

More
3 weeks 6 days ago #9962 by ClaudeMaina
Replied by ClaudeMaina on topic Quest Q-Jet motors (C,D)
I've flown 2 C12-4 motors so far (purchased from Aerospace Speciality Products during one of their recent sales). I really like the motors - the igniters not-so-much. I have had 2 out of 4 igniters fail so far. I'll be using the throughout the summer - hopefully I'll have better success with the igniters.

Please Log in or Create an account to join the conversation.

More
3 weeks 6 days ago #9963 by deangelo54
Replied by deangelo54 on topic Quest Q-Jet motors (C,D)
Once John Petrakis showed me how to properly install the ignitors, I have had good luck with the few C12-4's that I have launched. I launched one last Saturday at the MWRB launch. I have one left.

Please Log in or Create an account to join the conversation.

More
3 weeks 6 days ago #9964 by guyw
Replied by guyw on topic Quest Q-Jet motors (C,D)
And the way to properly install the igniters is ????

Please Log in or Create an account to join the conversation.

  • tlainhart
  • tlainhart's Avatar Topic Author
  • Offline
  • Junior Boarder
  • Junior Boarder
More
3 weeks 6 days ago #9965 by tlainhart
Replied by tlainhart on topic Quest Q-Jet motors (C,D)
The two dangling ends should be outside the motor.

Please Log in or Create an account to join the conversation.